HVAC & Plumbing Services in Alburtis, PA

Completed comprehensive preventive maintenance inspections on four Lennox heat pump systems and performed oil burner cleaning and servicing on existing heating system. Heat pump tune-ups included two units installed in December 2021 and two units installed in October 2018 located in attic space, with inspections covering both heating and cooling operational modes. Oil system service included nozzle replacement with either 1.00 X 45B or 90 X 45B specification. All equipment inspected, tested, and found operating within manufacturer specifications upon completion.

Performed maintenance service on MixMaster water softener/neutralizer system that had not been serviced in 3-4 years. Inspected regeneration cycle operation, verified system settings, and reset controls as needed for single-occupant household usage. Documented existing plumbing configuration including copper piping with visible corrosion at connection points and PVC supply lines with ball valve controls.

Responded to water treatment system leak originating from the rear of the acid neutralizer. Upon arrival, found leak at bypass valve assembly and successfully placed system in bypass mode to control water loss. Performed comprehensive inspection of entire water treatment system including acid neutralizer and associated components. Evaluated system for potential re-bed requirements and salt levels, noting last re-bed was completed with neutralizing solution mix in April 2024. Documented current system condition with photographs showing bypass valve configuration, piping connections, and treatment tank assembly for service records.

Completed comprehensive preventative maintenance inspection on Lennox 410A refrigerant heat pump system. Replaced and installed expansion tank, performed thorough blower wheel cleaning to restore optimal airflow, and added new REME air purification unit for enhanced indoor air quality. Installed surge protector to safeguard system electronics and added E-Z trap for improved condensate drainage and maintenance accessibility.

Responded to communication error between thermostat and hub displaying error code 31, causing unit shutdown after repeated reboots. Addressed condensate pump overflow issue with water spilling onto unit floor. Accessed control panel to inspect circuit boards, wiring connections, and communication components. Verified proper operation of condensate removal system and resolved communication fault between thermostat hub and HVAC control board to restore normal system operation.

Completed full HVAC system change-out, replacing existing equipment with Moyer Comfort Series heat pump and gas furnace. Converted fuel system from natural gas to propane using appropriate conversion kit. Installed 4-1/2" x 16" supply trunk with dual-direction airflow configuration and open return system. Performed vacuum test on refrigerant lines to verify system integrity prior to charging, confirming proper evacuation and absence of leaks in the heat pump circuit.

Installed Water Max WT water treatment system with acid neutralizer and iron-removing capabilities to address low pH water (5.8) and fine iron-rich sediment causing rust-colored residue buildup in plumbing fixtures and CPVC piping. System includes gray cylindrical softener tank (model WM 20MXQ 8IG) with integrated filtration components connected via PVC and blue CPVC piping with red ball valve shutoffs for system isolation. Installation required wall penetrations and plumbing modifications to integrate treatment system into existing water supply line, with patching and finishing work performed on interior wall surfaces around new piping runs.

Responded to no cooling complaint on 2018 Lennox system with S-20 smart thermostat. Upon arrival, system was running but not producing cool air. Diagnosed issue related to airflow restriction caused by dirty air filter despite customer reporting recent change. Removed filter temporarily to test system performance and confirmed improved air temperature output. Identified thermostat connectivity error that may have contributed to system malfunction. Instructed customer on proper filter maintenance schedule and thermostat operation to prevent future issues.

Responded to emergency call for rapidly accelerating leak in basement near well pressure tank system. Upon inspection, identified significant corrosion on existing plumbing infrastructure including pressure tank connections, valves, and associated fittings. Addressed immediate leak to prevent further water damage and system failure. Due to advanced age and deterioration of components, recommended complete system replacement including pressure tank, pressure switch, pressure gauge, relief valve, and shut-off valves. Documented existing conditions with photographs showing corroded piping, compromised connections, and overall system condition. Provided quote for comprehensive replacement of well tank package and associated components to be completed at later scheduled appointment.

Replaced shower head and added neutralizer mix and also change shower cartridge and handle

Heat pump inspection

Heat pump inspection

Installed zone control board.

Boiler inspection

Ac inspection

Ac inspection.

Ac maintenance service cooling repair

I completed a heating inspection on a Lennox heat pump. I checked the system's performance, inspected the electrical connections, and tested the thermostat.

Did a tune-up on a 11 year old Lennox signature series heat pump. Run capacitor on the outdoor unit was weak, replaced with a new one. System is running well.

Serviced 2 Carrier heat pumps, both are working properly and in good condition.

Heating cpp on two Lennox.

Completed oil boiler service and cleaning. Cleaned the oil nozzle assembly and replaced oil nozzle and filter. Verified safe and proper system operation.

inspected the boiler for any signs of wear and tear, such as leaks, corrosion, and damage. I also tested the boiler to ensure that it was operating at the correct temperature and pressure. After the inspection, I provided the homeowner with a detailed report of my findings and recommendations for future maintenance. I also offered to provide ongoing maintenance services to ensure that the boiler continues to operate safely and efficiently. Overall, the job was a success, and the homeowner was very pleased with the results. I am proud of the work that I did and look forward to completing more jobs in the future.

Plumbing service. Diagnosed no water as bad well pump. Replaced with new 1/2 HP well pump, new wire and pipe. Customer now has water

Completed cooling check on Carrier AC unit. Outdoor and indoor units were clean of dirt and debris. Everything looked good and working properly.