HVAC & Plumbing Services in Macungie, PA

Removed the existing natural gas furnace and installed a new Moyer Comfort 92% AFUE, 80,000 BTU direct vent gas furnace in the basement mechanical area. Fabricated and installed a return filter rack with connector to the existing return ductwork to accommodate the original 40-inch unit height, and reconnected supply plenum, gas piping, and venting for proper operation.

Completed comprehensive oil clean and service on 9-year-old heating unit. System was inspected, cleaned, and tested; all components functioning properly with no issues identified. Unit operational and ready for continued use.

Completed comprehensive CPM A/C inspection including cleaning of indoor blower assembly and replacement of indoor blower capacitor to restore proper system operation. Evaluated furnace venting configuration due to existing main chimney having a vertical crack requiring removal, and assessed alternative venting location options for future implementation.

Installed customer-provided kitchen faucet on newly installed countertop with double-basin stainless steel sink. Connected water supply lines and completed drain line installation, including integration of dishwasher drain connection to the system. All plumbing connections tested and verified for proper operation with no leaks detected.

Coordinated with water company for street-side water shutoff at 8:00 AM to facilitate replacement of defective street-side valve. Replaced toilet in main warehouse facility and completed miscellaneous plumbing repairs. Inspected and documented water heater installation connections including copper piping, PEX tubing, ball valves, and pressure tank components to ensure proper operation following water service restoration.

Completed comprehensive air conditioning tune-up and maintenance on two Lennox systems serving first and second floors. Performed standard preventative maintenance procedures including inspection of electrical components, refrigerant levels, condensers, and system controls. Cleared blocked condensate drain line to restore proper drainage function. Customer expressed concerns regarding refrigerant levels; verified charge on both units and confirmed systems are operating within manufacturer specifications with no refrigerant loss detected at this time. Both emergency disconnect switches and outdoor condenser units inspected and found in proper working condition with no issues reported by customer.

Installed and wired NEST thermostat in new residential construction to establish proper communication with air conditioning system. Verified system operation with airflow measurements at supply register reading 2985 CFM and confirmed proper temperature control functionality at air handler unit.

Performed air conditioning system check and provided thermostat operation education for new homeowner. Conducted electrical diagnostics on HVAC control panel, verified 24-volt control circuit operation reading 24.45 volts, and inspected all wire connections and terminal blocks for proper function. System found operating within normal parameters.

Completed comprehensive air conditioning maintenance check on system that was overdue for service following an emergency call from earlier in the season. Inspected attic-mounted HVAC blower unit, ductwork connections, PVC condensate drainage system, and electrical wiring throughout the installation. Verified proper airflow through system and checked filter status, bringing replacement 18x19x1 filter as backup. Proceeded to outdoor condensing unit where electrical diagnostics were performed using clamp meter, recording amp draw of 6.3 amps at the compressor. Inspected capacitor connections, contactor operation, and all electrical terminations at outdoor disconnect. System operating within normal parameters upon completion of tune-up.

Water softener recheck

Responded to no-ignition issue on Bradford White gas water heater with Defender Safety System that was recently installed. Unit displayed diagnostic fault codes with red light blinking 8 times followed by 4 times, indicating gas valve failure after homeowner had turned unit off while away. Replaced defective gas control valve assembly and restored unit to proper operation. Verified proper gas flow through yellow flex line, confirmed blue-handled shutoff valve operation, and tested ignition sequence. Unit now firing correctly with all safety systems functioning as designed.

Completed comprehensive preventive maintenance inspection on Rheem heat pump system installed in 2016. Performed cooling season tune-up including inspection of control board, electrical connections, capacitors, and wiring harnesses. All gas valve leak repairs were successfully completed as part of the service scope. Inspected and verified proper operation of condensate pump assembly and drainage system with associated PVC piping and electrical connections. All system components found to be functioning within normal operating parameters upon completion of maintenance procedures.

Completed new installation of Hague WaterMAX BEQ 2 water softener system in basement utility area, including piping up to 10 feet, all necessary connections, and salt delivery. Performed installation recheck and system verification of previously installed Moyer Comfort series air conditioning unit and gas furnace to ensure proper operation. Provided rebate packet with instructions for completion and submission, and collected outstanding balance prior to service completion.

Responded to emergency call for water line leak supplying toilet that could not be shut off, with water leaking through wall or ceiling causing significant water damage. Upon arrival, assessed the situation and located the source of the leak in the water supply line. Shut off the main water supply to stop active flooding. Repaired the failed water line connection to the toilet. Tested the repair to confirm no further leakage. Due to the extent of water intrusion through the wall and ceiling, recommended restoration services to address water damage and prevent potential mold growth.

Responded to no-heat call on Trane natural gas furnace experiencing delayed ignition and short cycling. Inspection revealed failing blower motor with visible copper windings and dust accumulation. Replaced motor assembly and verified proper ignition sequence and continuous operation, restoring normal heating function.

Successfully installed a Daikin MXM Ductless Heat Pump system serving two rooms (son's bedroom 11'x13' and office 14'4"x14'6", both with 8' ceilings). System includes 12-year parts and labor warranty and Gold Comfort Partner Membership for one year.

Heat pump inspection

Boiler cleaning.

Ac inspection

Did an AC check on a 7 year old Lennox Elite heat pump, System running well. Capacitor was beginning to fail, had lost ~30% of capacity. Replaced with new one and tested for proper operation. Outdoor coil had moderate buildup on the coils, cleaned.

Installed 3-ton Moyer Comfort Series Enhanced Capacity Heat Pump.

Zone valve head had failed on a propane boiler.

Gas valve replacement.

Heat inspection

Replaced section of trunk duct that had been soaked from a leak. Also replaced a piercing valve with a quarter turn valve and an expansion tank for the water heater.